IKEA Skadis Peg board snap fit connector (V2) - Free 3D Print Model

Search models, users, collections, and posts

FishSoup25

Tools>Organizers

IP Report

Print Profile(3)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

4 full sets , 0.2mm layer, 2 walls, 15% infill

41 min

1 plate

4.8(56)

Horizontal to connect boards by the side

38 min

1 plate

5.0(5)

A bit smaller to fit custom board

37 min

1 plate

4.8(4)

Open in Bambu Studio

Boost

344

1076

1.1 k

661

Released

Description

Hi, I needed to hang one IKEA Skadis under another and decided to design this snap-fit connector. Print without any support. To install it put two IKEA Scadis pegboards on the floor, take the longer connector part and put it underneath peg-boards. Then slowly apply pressure until it fit into the board. Then close it from another side with a second connector piece. The connection is pretty tight so might want to use a mallet or a piece of wood to close two parts together. Be careful while moving the boards until you install all the connectors because 2-3 connectors will not sustain the weight of the boards and might break. Leave a comment if you have a question or suggestion.

UPDATE 31.07.2020

I've uploaded a new file which is version two. It combines both male and female parts as suggested in the comments. I haven't printed it yet, but the model is the same, so it should work the same way.