Search models, users, collections, and posts
Korg Volca Contemporary Stand
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
6.1 h
1 plate
Open in Bambu Studio
Boost
3
11
1
0
6
4
Released
Description
The Korg Volca desktop stand I designed specifically for my environment. I wanted to raise a single Volca just a bit above the back edge a keyboard, angled so it's easy to see and reach, and I wanted something a bit stylish and fun.
My Volca drum has a very snug fit. Sliding the unit in from the side is required.
Pictured printed in Overture Rainbow Sunset PLA.
You may notice the 3MF has a grid on the bottom but the STL does not. I usually subtract a thin grid from to bottom of objects with a large continuous bottom surface to improve adhesion within Bambu studio.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)