Holder for spray bottles on 45mm pegboard
Print Profile(2)
Description
Suitable for aerosol/spray bottles (max ø68mm)
Typical size for common spray bottles like Dichtol, Weicon, or WD-40. The 3D model is parametric; the number and size can also be adjusted for other variants using the "bottle_count" and "bottle_diameter" parameters
Compatibility
Designed for Euro pegboards with a 45 mm keyhole grid, as commonly available on Amazon (e.g., the Arebos tool wall here in the photo) or in hardware stores
⚠️ Warning: Some manufacturers use different grids (e.g., 37.5 mm for Küpper). Even if these pegboards look similar, these grids are not directly compatible. However, the Fusion model is attached and parametrically designed. Adjusting the hole spacing using the "pegboard_grid_distance" parameter should be sufficient in most cases
On the back of the holders there are optional recesses for three ø6x3mm magnets. The use of magnets is optional, but it helps ensure the holder is less likely to slip
Print Recommendation
To prevent the small grid tabs from breaking off when inserted into the pegboard, printing with PLA is not recommended. The holders shown in the photo were printed with ABS, but PETG would be just as sufficient
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)