Search models, users, collections, and posts
Emco Unimat 4 chip catcher insert
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
30 min
1 plate
Open in Bambu Studio
Boost
1
1
0
0
1
0
Released
Description
Simple cover that slides into the lathe bed to stop chips dropping through to the ground. Can be slid in and out easily as needed. Tested on an emco unimat 4 but I believe it should also work on the emco unimat 3 as well.
Tested with the carriage and tailstock in place and works fine clearance wise
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)