Segway navimow H1500 spikes
Print Profile(1)
Description
These spikes go outside of the tires of the Navimow to help with slipping, especially when backing up slopes. To mount the spikes you simply remove the three screws in the holes on the inside of the wheel, and change the original wheel caps for them. This way there is absolutely no permanent damage to your mower. To mount the spikes you need 6 x m4 x 35mm and six m4 hex nuts go inside the printed hex holes, which leaves a flush surface. 30mm long screws should work fine, but will be a bit harder to mount. The hub is not needed but makes it look a lot better. Should be printed in PETG/ASA/ABS for durability
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)