Supernote A5x Half Folio DIY case

Felt that none of the available cases for the a5x were similar to the ones for Manta

Modified existing case design on printables to create the two sides. Cut off 2mm from edges since this is just sides that fit on top of the device. Modfied the back plate to have the rail and back cover to be one piece but have one plate with just the rail. 

I used a leather sheet and glued it on top to the two parts, have since glued felt/chamois on the other side with a pen loop. You can instead use TPU or print in solid colors and just glue in a leather or cloth spine

Wont be able to print on smaller print beds as one unit. Will see if I can split the parts for smaller print beds

Top and bottom parts are separate and meant to be held by some fabric or tape like book. 

Working on updating the top cover to include a hole for magnet to trigger the hall effect sensor.