Search models, users, collections, and posts
Banshee (BNC-3E) for Battletech
IP Report
Print Profile(1)
0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill
Designer
4.9 h
1 plate
Open in Bambu Studio
Boost
4
32
2
0
10
1
Released
Description
This model is based off of the CGL sculpt. It was designed for the 0.2 nozzle but should work well with the 0.4.
PARTS:
This model is printed in one piece and comes with a hex base (by the way, the hex doesn't have a hole like it does in the picture).
Community:
I am planning on posting other Banshee variants as well as doing this one in other poses. As you can see, this Banshee is just standing. If you would like to see a certain pose leave it in the comments and I will consider doing it (especially if there's only one or two requests).
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)