Canon RF 90mm Prime Wine Red Lens
Print Profile(1)
Description
Model Introduction
This is a modification solution for a wine-red industrial lens for Canon RF series cameras. The 90mm prime lens is equivalent to a 144mm prime lens on Canon APS-C, suitable for the wine-red industrial prime lens with a front diameter of 48mm, a rear diameter of 43mm, a length of 55mm, and a focal length of 90mm, as shown in the figure below. It is equipped with manually adjustable aperture and focus rings, and it has been verified on Canon R7 and Canon R50 APS-C cameras that it can focus to infinity
Boost Me (for free)
This model is excellent, I want to give it a boost!
Parts List
- (Required) 90mm wine-red lens x1
- (Required) Screws:
- m3x6 3 pieces
- m3x4 4 pieces
- m2x6 6 pieces
- (Required) RF to M42 adapter ring: To prevent the 3D printed RF mount from breaking inside the camera, it is recommended to buy a metal ring, which costs only a few dollars
- (Optional) 58mm UV filter, can be directly screwed onto the outermost thread of the aperture
- (Optional) 58mm lens hood (the lens hood in the model currently has a bug and cannot be reversely mounted, it may be optimized later)
Printing Configuration
Refer to the table below
Note:
1. The lens hood on plate 9 currently has an unaddressed bug; it can only be mounted normally, not in reverse. Please consider whether to print it, and if purchasing, choose a 58mm lens hood.
2. When printing plate 14, a pause needs to be added at layer 27 to insert the ring from plate 11, then resume printing.
plate print head layer height infill supports corresponding part plate 1-5 0.4mm 0.08mm 100% none focus ring plate 6 0.4mm 0.08mm 100% tree (auto) focus ring plate 7-8 0.4mm 0.2mm 15% tree (auto) lens barrel plate 9 0.4mm 0.2mm 15% none lens hood plate 11 0.4mm 0.08mm 100% none aperture plate 12-14 0.4mm 0.2mm 15% none aperture
Installation Video
- To be released later
References
- For the aperture, I referred to the following link: Aperture
- If you need a lens cap, it is recommended to print this one: Lens Cap. It has been tested and works, just choose 58mm
- If you need a lens cap for the RF mount end, it is recommended to print this one: RF Mount Lens Cap
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)