Folding Table

Folding Table

With so many Guangzhou stool models, how can you miss a folding table? It's specially designed for gatherings. Quickly invite your friends to join the feast!

There are few parts and not much filament needed, a single spool is enough for a monochrome print. The square table top measures 10*10cm, scale 1:10

Installation:

• No hardware is required; connections are made directly with filament.

• Tools needed: lighter, small pliers, a segment of filament

  Refer to this image for the entire installation process, paying attention to the installation direction

  

  Begin installation

  1. Assemble the two main legs, note that the shorter one is on top. This must not be wrong. Heat one end of the filament with a lighter, gently press it onto the iron to cool, thread it through the hole, then heat the other end, press firmly, do not loosen

  Since there is no gap between the joints, some areas must not have protrusions, as noted in the diagram (the model has small grooves designed)

  

  2. Install the U-shaped tube

  

  3. Connect the tabletop. Steps 3 and 4 have no fixed order, do whatever is convenient, but the direction must not be mistaken

  

  4. Complete the main body

  

  5. Bend the legs: Use a lighter to heat the indicated bending points for a few seconds. Bend to the desired angle, then blow to cool and set. Be careful not to burn your hands. Done.

  

  Installation review: Don't underestimate it; it's quite difficult and laborious. I succeeded only after 2 attempts. Pay special attention to the direction. Why design it with straight legs and then bend them? This makes it sturdier and requires no supports. Those who know, know.

  Once installed, it's very delicate and gives a great sense of accomplishment. Give it a try!

  Note: The Guangzhou stool in the main image is not this work. Guangzhou stool's work name: Guangdong Provincial Stool (Guangxi also) Author: Leihou Mechanical Design Thanks