Cammy White aka Killer Bee - Street Fighter

Cammy White aka Killer Bee – Street Fighter

Like all models, this model is separated into different parts and put together with connectors. This allows you to print them in large sizes even with an A1 Mini. Additionally, if a print fails, you don't waste too much time or filament.
I try to position the cuts so that there are minimal visible support structures left.
If you feel the connectors are too tight or too loose, you can simply upscale them in BambuLab Studio for a better fit. 

The total height of the figure in my print profile is about 25 cm.

Torso:

I made two options, with and without torso straps. Be aware, in order to remove the support structure from the torso with straps, you need a scalpel or some other small tools like a wood carving chisel. I recommend a scalpel blade in chisel form.
You can always test removal of support structure by cutting down the torso to its lower part in bambu, print, and try to remove it. 
 

Head:
Because the hair strand/tendril is quite flimsy, I added two head options. One with and one without a cutout for the hair strand/tendril on the forehead. You can print the strand/tendril separately, I recommend a 0.08mm layer hight and normal support structure with style snug/seamless. Should already be set in my settings.

Legs:
You can print the leg strap and pouch separately, it should fit perfectly. Also you can rotate the legs slightly if you want, because on the default rotation you can see where the support structure supports the left lower leg on the backside. Or you try different settings for support interface.

Braids:

I painted the necessary support structures, I recommend also settings of 0.08mm layer hight. 

Important Note!
This print may includes small and fragile details (esp. hair and fingers). It printed fine on my tests with my setup, but your results may differ.
Please print at your own risk and adjust supports/settings as needed, especially if you have limited experience with delicate prints.
If you experience any problems, try experimenting with support structure settings and layer height.

Transparency
I am not the creator of the original model (orig. kluvarn)
My work included posing and editing to make a printable model.