90 * elbow (long) for Exfog unit - Airsoft

90 degree elbows for use with Exfog 0.25in/6.4mm tubing

I ran into issues when trying to set up my Bolle tactical goggles with the Exfog QD kit and my boonie hat. In the past without the qd id have the tubes slip under the side of the goggles, but with these QDs the only mount point for my goggles was from the top. Only with the tubing coming from behind my head and turning 90* straight down to meet my goggles, the qd would split or the hose would kink. It was a real pain. I looked for these elbows, but could not find anything, so I adapted a file I found for 16mm tubing to fit the provided Exfog unit tubing. These work like a charm!

Print with supports, it will have them internally, but with a little patience you can get them out.

I also recomend gluing in the tubing once you have everything to a length you like. Even with the factory tubing, sometimes the tube comes off of the adapter, rather than the magnetic coupling letting go. Glue aleviates that. 

This is the long prong version, itll have better grip, but might be too long for some applications when you need the QD as close to the elbow as possible. I also have the short prong version shared. Be aware you MUST glue the short prong as its holding power is compromised by loss of length.