droboto

cover

Browning's Buck Mark 22LR Basepad V2

plate_1.png

0bd3c74e240a2ff6.jpg

<ul><li>Cut a small straight line through the supports, a center line would be fine. that would give you room to pull them to the center and remove them easily. It would take a minute.</li><li>When removing them, put your fingers over the slimest part of the piece to avoid damaging it</li><li>40% infill should be fine but I&#39;d go with 99% if it&#39;s PLA.</li></ul>

0.2mm layer, 4 walls, 40% infill

This is a magazine base pad for Browning Buck Mark Plus Steel UDX. I made it from scratch but I found good value and inspiration on <a target="_blank" rel="noopener noreferrer ugc" href="https://makerworld.com/en/models/1753747-brownin-buck-mark-22lr-magazine-basepad#profileId-1864770">@Migrain&#39;s design</a>. This version has a cover to close the gap behind. Perhaps a little bit of glue would be needed after adding it. I suggest do it on the sides to avoid glue into the magazine.&nbsp;I am thinking about version 3 with a screw on the bottom…

Print Profile(1)

Description

Comment & Rating (0)

License

Related Models