Search models, users, collections, and posts
Airsoft Golden Eagle M870 Shell Holder
IP Report
Print Profile(1)
PETG 0.16mm layer, 4 walls, 30% infill
Designer
2.6 h
1 plate
Open in Bambu Studio
Boost
20
44
0
2
21
8
Released
Description
Shell Holder for the airsoft Golden Eagle M870 (M8870) shotgun.
You will need:
2x M3x8mm countersunk screw
1x M3x12mm countersunk screw
The shell holder is mounted underneath the existing rail on top. The 2 M3x8mm screws go through the front 2 holes, whereas the M3x12mm screw replaces the screw at the rear sight.
Shells can be inserted from either below, or above.
Provided print profile is for PETG, which I recommend using. PLA can be used but might be too weak for anything other than display purposes.
Boost Me (for free)
If you get some use out of this, please consider leaving a boost. It'll be much appreciated :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)