Animal Cracker Bear Cap

After making the Starbucks Bearista Cap for honey bear jars, I was asked about making one for the animal cracker bear containers. After getting the threads right, it took some time to get the design to sit low enough to look good. This is the base cap. 

I am working on a set (like the honey bear I made) that adds the Starbucks name at different angles around the cap to accomidate different threads on the containers. 

This does require supports, and there was a little bit of cleanup required after removing them, but the come out clean and leave a pretty nice surface underneath.  

I'm also going to be honest and point out that it is the same hat as the smaller one I made, just scaled up, so it is a little lower poly.