Pen holder in light steampunk design
Print Profile(2)
Description
This is a pen holder in a light steampunk/industrial design. Since I had problems with my filament, the print quality seen in the photos is somewhat poorer than usual for Bambu Lab printers. The print quality should be better with a different spool and therefore normally cause no problems. My prototype, printed previously without these issues, shows good print quality as I expect from my printer
The lid of the boiler is pivotable and removable
The support structures are difficult to remove in some places. I therefore recommend removing them very carefully or using materials that are easy to separate from each other
Assembly is quick: Insert the lid of the front boiler with the thin end into the small hole between the two largest boilers. - Done
I assume no liability for property damage or personal injury arising from downloading, handling, editing, slicing, printing, and/or using the file, the print profile, and/or the model. The same applies to the printed model(s)
By performing any of the aforementioned actions, you agree to this
I do not assume any liability for material or personal damage caused when downloading, handling, modifying, slicing, printing, and/or using the file, the print profile, and/or the model. The same applies to the printed model(s).
By performing any of the actions just mentioned, you agree to this.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)