Search models, users, collections, and posts
Window Exhaust Outlet - 4" hose
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.7 h
2 plates
Open in Bambu Studio
Boost
4
26
0
0
17
11
Released
Bill of Materials
Bambu Filaments
Select all
Description
My wife needed to vent her kiln out the window through an exhaust pump with a 4" outlet on it. There wasn't a nice, clean way to attach the 4" dryer hose to the window so I made this. It was prototyped in PLA and printed in PLA-HT. YMMV on materials depending on how far away from the heat source your outlet needs to be. We anticipate over 100c so we went with high temp PLA. My original version only had 0.1mm of relief on the dovetail and I ended up having to trim a bit to snap it in place, so this version has 0.2mm
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)