CZ 457 or Savage MkII Magazine Box

Summary

9/13/2025 Added original box version I had forgotten about that holds 6 mags, instead of having tool compartment.
2/22/2024 Advised this box will also hold Savage Mark II 10 round magazines.
9/21/2024 Added two Savage labeled lids and one blank lid.

8/7/2023 I added a version 3 of the mag box. The previous version is a tight fit. Version 3 adds 4mm to the box height allowing more room between base of magazine and lid.

12/6/2023 Added a lid with CZ 452 marking

This is a box with slide in lid designed to hold five 22LR magazines, loaded or unloaded, for a CZ457. There is an additional front compartment to hold notes on ammo, small tools or in this case, my Leatherman Squirt. The lid slides on and off very easily. If you want a tighter lif fit, you might increase it’s size 1 or 2 percent on the X axis in your slicer and hand fit, or just stick a small foam block in the front compartment to give a bit of drag.

if someone would like me to change the lid to reflect a CZ 455 or 452, ask and I will make one up.

This was designed to print well without supports. You don't need to add them for the slot the lid slides into

Print Settings

Rafts:                      

No

Supports:                      

No

Resolution:                      

.2

Infill:                      

50%

Filament: Overture Professional PLA                Red                    
                        

Notes:                     

Prints well without supports