Mario

Super Mario - Gym Bros

With Peach under constant threat Mario has no choice but to save her, however all this running and jumping is taking its toll on our pasta loving plummer. Only one choice, get buff and get fit. This muscle man Mario is ready to make on the threats of the mushroom kingdom and bowser himself. lifting him this time with one arm while throwing him around. With his iconic outfit, in red white and blue, moustache and gloves he stands tall and definant. 

Printed in parts - NO AMS needed! Glue needed for securing most parts togther, however the end result is absoutely worthy of standing in your gaming setup, be it on your desk on on a shelf.

While printing Bane in his blue shirt another character seemed to fit the well deserved buffness of the model I was making, so I set about using assets I had created from that model to make this one. yes i did create a bane mask for Mario too, however it diddnt seem to look right, Mario being a villain. Available for those that want to give it a go however, just ask!

📌 Recommended printing settings:

• Material: PLA
• Layer height: 0.16 mm
• Infill: 15%
• Nozzle: 0.4mm

supports where nessesary - I have tried to make it so all have a surface contacting the plate however due to the detail and complexity of the modeling they sometimes require alot of support, so be aware and be carefull during support removal. Use a naked flame gentley and for short intervals to clean surfaces after removal

Assembly – Recommended Method on multipart models

• Dry fit: Assemble all parts without glue to check alignment and fit.
• Cleanup: Lightly deburr edges and pegs where nessesary with a file/modeling tool to ensure uniform contact. All parts are tested and fit together.
• Optional fix: Use glue for permanent assembly.

NOT AI, NO AI COLOUR PICS WHICH DISGUISE A POOR DETAILED SINGLE COLOUR PRINT. REAL PRINTED RESULTS!

MOST OF MY MODELS ARE FAN ART RECREATIONS AND ARE FOR PERSONAL USE ONLY  : MY MODELS ARE UNOFFICIAL FAN ART AND ARE NOT AFFILIATED OR ENDORSED BY THIRD PARTY IP HOLDERS

Thankyou to everyone who has rated and boosted my prints, if you like the models and want to continue to support the creation of more please consider boosting, it really does help incentivise the creation of more models for makerworld. 

If you would like to "buy me a coffee" to support the continued creation of fun prints you can do so here;

All of my models posted here are free for you to use commercially for free. I make them as a hobby and a bit of fun, with the points helping supply filament and consumables. All i ask if you wish to support my designs and want to sell them is that you are aware of the IP infringement which apply to some of the models and take appropriate responsibility. Please also boost them as much as you can and help with the points and please correctly attribute the model design to this page in your descriptions etc - Thankyou again everyone!