ER11 Collet Box with Sliding Lid
Print Profile(0)
Description
Summary
This is a box for ER11 collets. It has extra room to hold a ½” shank collet holder with up to a 5” shank, collet wrench, Allen wrench, pencil, church key, or other small essentials. The box is a very robust design, strong at 50% infill and I’m guessing it will do well at lower infills.
There are two slide-in lids. One is slightly over-sized so you can dress to a custom fit, the second is a very loose fit that will slide in and out without resistance. There is only 1.5mm difference in the width of the two tops.
The collet box can be printed without supports.
Boost Me (for free)
I'm just a geezer doing 3D printing and design to keep my brain active until I start CTD or become DRT. A little positive attention keeps me going. For you non old school emergency personnel, or those who only know modern approved abbreviations:
CTD is Circling the Drain and DRT is Dead Right There
Cheers!
Print Settings
Rafts:
No
Resolution:
.2
Infill:
50%
Filament: Overture PETG Grass Green
License
Comment & Rating (0)