Search models, users, collections, and posts
Print Profile(3)
0.16mm layer, 2 walls, 15% infill
Designer
27 min
1 plate
70mm x 37mm tealight diffuser
Designer
1 h
1 plate
70mm x 35mm tealight diffuser for smaller lights
Designer
1 h
1 plate
Open in Bambu Studio
Boost
42
152
7
0
163
143
Released
Description
I took original stand, broke it into parts, and widened the lithophane gap by 1.5mm to 4.5mm. I was just going to scale model up, but it made tealight holder too big. This keeps the light holder the same size, roughly 37mm.
I bought a 12 pack of twist on/off tealights from Amazon for about $10USD. As they are a bit brighter, and are 30mm in diameter. These provide good light, but its directional, so I designed a simple diffuser to slide over light, and it really helps spread the light across the lithophane, which I will post as a stand alone model.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)