E-Scooter Throttle under Grip for Kukirin S1 Max
Print Profile(1)
Description
E-Scooter Throttle for Kukirin S1 Max, that you can put under the stock-grips. You just take the stock one of, slide the print onto the bar and put the grip back over. This can be a little difficult. I first put the grip in hot water (Not to hot!!!) and used a little bit sope or hairspray to slide it easyer. I hope you like it.
Attention: Disclaimer – DIY Throttle Extension This upload contains a digital 3D model file only. I do not manufacture, sell, distribute, or supply any physical product. This model is a hobbyist experimental DIY prototype 3D file, designed for further digital development. It is not designed for real usage. It is not an original manufacturer part, not safety-tested, and not certified for any use. Any real installation and use could cause serious DANGER!!! The author provides this file for privat, informational and experimental purposes only and assumes no responsibility or liability for any damage, injury, malfunction, or legal consequences resulting from its misuse.
|
Boost Me (for free)
Hi, I put a lot of effort into this print, finding the best measurments,etc. If you like it, you can may leave a comment and a like. I would appreciate if you Boost me. Things like that motivate me and help me keep going. Thank you!
- ASSEMBLY:
- Slide the old grip off
- Put the print over the bar
- Slide the grip back over the print (This can be a little difficult. Be carefull, don't twist it, it could break!)
Done!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (5)