Dicker Max Self-Propelled Anti-Tank Gun - 1/72 Scale

Courtesy to:

https://www.thingiverse.com/thing:2090672

Panzer IV Pack (Retread)
by TigerAce1945 is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.

Remix:

Rescaled from 1/100 to 1/72. Adjusted placement directions for the ease of printing.

One model included:

1. “Dicker Max” (Pz.Sfl. IVa) Self-Propelled Anti-Tank Gun IV Model A   - 大麦克斯自行反坦克炮

• Vehicle is printed in one piece. Recommend having a sprue cutter/nipper to help remove the supports. 一体式打印. 推荐用水口钳移除支撑
• Please carefully remove the support for the gun barrel. Gun is easy to break since it is thin and long, hold the barrel with hand then remove the support at the tip position. Never remove from the root of the support. 请小心移除炮管支撑, 炮管细长极易折断. 握住炮管并移除顶部的支撑, 勿从底部开始
• There is a tiny bent on the emission tube at the back right of the hull, be careful when removing the support. 请小心移除右后侧弯曲的排气管的支撑
• (I printed two of them, got these two fragile broken parts above :(, so listed them as reminders) 我自己打印了两台, 分别折断了上述两个脆弱件
• Due to the printing placement to accommodate inner details of the open fighting compartment, the back of Dicker Max might be a bit rough. 打印朝向是为了更好的呈现开放式战斗室内部, 车体背面会有一些粗糙
• The printing profile I'm providing should be sufficient for gun's printing. If encountering printing problem, please leave a comment with details. I can add another profile with heavy support for the gun. 当前的打印设置应足以打印完整炮管. 如遇问题, 请留言并描述细节. 可上传另一个给炮管加大支撑的配置