License Plate Holder Gilera Runner FX FXR SP
Print Profile(2)
Bill of Materials
- M5 Unterlagsscheibe x 12:
- M5 Selbstsichernde Mutter x 6:
- M5x16 Schraube x 4: Zur Befestigung hinter dem RĂźcklicht
- M5x10 oder M5x16 x 2: Zur Befestigung des VA Kennzeichenhalter
- VA Kennzeichenhalter Motorrad x 1: findet ihr leicht auf eBay / Amazon
Description
đ Description
Simple license plate holder for Gilera Runner 50 / 125 / 180 SP FX FXR
The angle when mounted is approximately just under 30°
Use with a 0.8 mm stainless steel motorcycle license plate frame is recommended, as a reflector is mandatory in Germany
đ§ Assembly Instructions
- Trim the original fender flush with the fairing
- Make the cut edge as shown in the picture
- Remove the taillight beforehand
đŚ Scope of Delivery
- 1x License plate holder
- 1x Drilling template
đ Versions
A reinforced version (V2) has been added
- Angle after assembly not yet finally tested â may vary slightly
- V2 is significantly stiffer and reduces vibrations
Vibrations can still occur, as they are transmitted from the 2-stroke engine to the bodywork due to its design
â ď¸ Note
No liability for assembly errors or legal regulations
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (4)