Search models, users, collections, and posts
FEP Squeegee (No Hardware)
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
2 plates
Open in Bambu Studio
Boost
11
17
5
0
28
36
Released
Description
Squeegee is printed with TPU, the handle I used PLA. I printed the handle on its side with supports, and it turned out okay. It was a bit of a tight fit to get the TPU into the handle, but once it was seated properly, it is very firmly attached.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (5)