Search models, users, collections, and posts
Particle Boron + Adafruit SHT41 enclosure
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
2
1
0
0
3
2
Released
Description
Enclosure for the Particle Boron cellular development board and Adafruit SHT41 temperature/humidity breakout board.
Recommended to print with PETG and with supports enabled.
Both boards and the cover are held by M2 screws. The Boron can be mounted directly or paired with an expansion board (shown in images). If paring with an expansion board I would recommend using M2x16mm screws, otherwise use M2x4mm screws. The SHT41 breakout board should be mounted with M2x4mm screws. Use a single M2x4mm screw for the cover.
The enclosure can also be used for Adafruit feather products as the Particle Boron development board shares the same footprint.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)