Classics Jetfire - G1 Armor

This is an accessory set to give the 2006 Classics Voyager Classics Jetfire a more G1 look. 

The shoulder pack and arm guards look amazing. The G1 syle helmet, however, does not. It explains when they the helmet on the 2006 figure didn't match the original head.  Use small screws or a piece of fillament to attach the antennas.

The parts are split to limit the need for suppports. There are alignment holes intended for a 5mm long peice of 1.75mm fillament. Use superglue to hold the parts tegether.

There 3 backpack connector components: 

Robot Mode - Moves booster back to display correctly in Robot mode
Robot Plane - Moves the booster forward to Look correct in Plane mode
Robot Angle - Adjusts the angle of the booters slightly towards the front in robot mode (I think it looks better)

Try to find an opaque red fillament. I used the Bambu Basic Red PLA. The color looked great, but it's a bit translucent and the black shows though in places.

I reccommend keeping the print orientations the way they are in the .3MF. Printing other ways will compromize strength, especially where the backpack connects to the figure.