Flitsmeister DOT - Magnetic backplate
Print Profile(1)
Description
A custom backplate that twists in place to the back of the FlitsMeister DOT similarly as the original backplate with double-sided tape.
Only this backplate holds 3 magnets (round - 2mm x 5mm - see picture with countermagnets attached on outside)
This way you can easily remove and add the FlitsMeister DOT to a custom designed holder + more easily switch it between cars (if you like).
The cut-out in the middle is to screw and unscrew it easily with any coin that you have around....
The print profile pauses when you have to insert the magnets in the cut-outs.
I advise to design the holder with following specs:
- Sunken hole with diameter of 30mm and about 1mm deep (provides extra support
- from the center of this - place 3 magnet cut-outs (distributed evenly over the 360degr) - with a center-to-center distance of 10 mm. Position the bottom 2 cutouts horizontally for correct orientation.
I'll add a mount later on and share it as reference / example...
!!! contact me if you require custom 3d design work or 3d prints delivered: info@kooda.be !!!!
If you wish to support my work:
https://buymeacoffee.com/kooda
Boost Me (for free)
Boost me and my products
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)