Firefighter Figurine V1
Print Profile(1)
Description
đ¨ Print Settings for low fillament use.
⢠Layer height: 0.16 mm (High Quality)
⢠Seam position: Back
⢠Infill: 2% Gyroid
⢠Supports: Tree Supports (Support only critical regions enabled)
You can print with 10-15% gyroid and  Tree Supports (Support only critical regions disabled) for best results
Clean details, optimized for smooth finish and minimal post-processing.
You can find the entire collection in my 3d models.
If you print it, donât forget to upload your make and follow for the next characters in the collection đđĽ
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)