J hook for nylon strap webbing bike rack support

***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***

##  These models printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##

**** Disclosure Use At Your Own Discretion, Cautiously!! USE PETG or Stronger filaments such as ASA ABS PAHT-CF ETC, NOT RECOMMENDED FOR PLA ****

***Not Responsible for any damages from use of my design, again use with caution and at your own discretion! No Guarantees that these will work in any other manner than they are intended, for simple side support strapping non weight bearing positions. I have hand sewn them with heavy duty Nylon thread to secure them to the strapping in a “Box X” pattern***

This is a simple trunk/hatchback J-hook side mount clip I designed in Tinkercad to replace broken and lost trunk hooks for my trunk/hatchback mounted bike rack. THESE ARE DESIGNED TO USE AS SIDE STRAP STABILIZERS ONLY!! NOT FOR THE TOP SUPPORTS, AS THEY HAVENT BEEN TESTED TO SUPPORT THE FULL WEIGHT OF THE WHOLE RACK.

Printed with 8 walls (solid) on the side to add strength with minimal support.

They were printed in orientation as shown and printed with ZERO issues.