Gridfinity TS100 All-in-One Organizer with Dust Cover

This is an all-in-one solution for a TS100 soldering iron for use in the Gridfinity organization system by ZackFreedman

This is clearly inspired by both ZackFreedman's Gridfinity Pinecil + TS100 Tips and Tool Holder and pelrun's Gridfinity TS100 soldering iron holder

This 1x1 Gridfinity box will hold:

• TS100 soldering iron body
  (NOTE: only designed to fit in the orientation shown in the photo, with the tip end inserted and the power port on top)
• 3 soldering tips
• standard 2.5mm hex key
• Spare screws, such as spare tip retaining screws using a recessed 6x2mm magnet (the same size as is used in the bottom of the Gridfinity design)

There is also a second STL for a dust cover – since I don't use my iron too frequently, but I want it sitting out on my Gridfinity tray, I wanted to make sure to protect it. The cover must be printed in vase mode and will slot in to the Gridfinity ridges in the organizer.

NOTE: Even with the cover, this model is not designed to have more Gridfinity containers stacked on top!

This was my first attempt at modifying a Gridfinity design and I'm also just beginning to learn 3D design as a whole, so I'm sure there are other optimizations that could've been made.

Print settings:

• The base should be printed with typical Gridfinity settings. Low infill (use whatever you need to get nice top surfaces) and no supports needed.
• The cover must be printed in vase mode

Update History:

• 06 May 2023 - Finally remembered to come back and upload a filled in cover…
• 26 Sep 2023 - Migrated models to MakerWorld. I will try to find time to get some print profiles in the future.
• 28 Sep 2023 - Added basic print profiles for each model