Police Signal Paddle STOP/GO

Since my son's police costume was missing a police paddle and I couldn't find one, I quickly created it.

After printing the paddle, I recommend re-measuring the depth and also the diameter before printing the red and green parts, as tolerances can vary with different printers.

Also, please check your printer settings beforehand and feel free to adjust them.

For the supports, I have set an upper and lower distance of 0.22mm, as this measurement works well for me.
The handle is printed lying down deliberately, as it is more stable this way. Upright is prettier, but not as stable.

Finally, I fixed the plates with a few drops of glue.

Feel free to edit it and share your results.
The lettering “Stop” and “Go” can also be inserted.

I look forward to your results!

The silver I used was from eSun, as the Bambu one wasn't full enough anymore ;)