99X25X2 PIPE GASKET

GASKET FOR 100MM PIPES FOR 3D Printed FUME EXTRACTION SYSTEM.

I NEEDED TO AVOID LEAKS IN THE 100MM PIPE CONNECTIONS EVEN THOUGH I HAD INSTALLED METAL CLAMPS.

SO I MADE THIS GASKET IN ESUN TPE 83A THAT I HAD, BUT IT CAN ALSO BE MADE WITH CLASSIC Bambulab TPU 95A WITHOUT PROBLEMS.

THE PURPOSE IS TO INSERT THE GASKET INTO THE INNER PART OF THE Y PRINTED TOGETHER WITH THE AIR EXTRACTOR, TO ELIMINATE THE SMALL GAP THAT SOMETIMES REMAINS WHEN THE PIPE IS SLIGHTLY WIDER, THUS AVOIDING ODOR LEAKS IN THE ROOM AND ALSO AVOIDING REPRINTING THE ENTIRE Y TO THE THOUSANDTH.

IF YOU NEED DIFFERENT SIZES, YOU CAN WIDEN OR TIGHTEN IT USING BAMBUSTUDIO AS YOU WISH, OTHERWISE WRITE TO ME AND I WILL TRY TO HELP YOU.

MATERIAL USED: ESUN TPE 83A (VERY SOFT)

3D Printer: BAMBULAB H2D

WALLS: 2

INFILL: 0%

LAYER HEIGHT: 0.2MM

NO SUPPORTS

IF YOU LIKE MY CREATIONS, HELP ME WITH A BOOST TO CREATE EVEN MORE USEFUL ACCESSORIES.

THANKS TO ALL