Starfield Constellation Logo Keychain / Pin Top

STARFIELD CONSTELLATION LOGO KEYCHAIN / Pin Top

     Constellation logo from Starfield made as a multi-color keychain or Pin Top.

     Diameter is approximately 45mm (about the size of a poker chip / large coin).

Two versions included:

• With keychain loop
• Without loop (for butterfly clasp backs)

Files included:

• STEP files
• 3MF files

IMPORTANT IMPORT NOTE:
When importing into Bambu Studio, import as ONE object with multiple parts. Bambu Slicer may ask to rescale the print because parts are too small — select NO. Do not allow it to automatically rescale during import. The model can be resized normally after it is fully imported (as long as extra steps are taken to adjust color changes or z-height remains the same)

AMS and Pause Setup

This model uses 8 colors and requires an AMS. With the typical 4 slot AMS setup 2 pauses are required

Add pauses at:

• Layer 7
• Layer 10

AMS Setup 1 (Start of Print)
Slot 1 – Black
Slot 2 – White
Slot 3 – Blue
Slot 4 – Light Blue

AMS Setup 2 (After Layer 7 Pause)
Slot 1 – Black
Slot 2 – Dark Blue
Slot 3 – Blue
Slot 4 – Light Blue

AMS Setup 3 (After Layer 10 Pause)
Slot 1 – Black
Slot 2 – Red
Slot 3 – Orange
Slot 4 – Yellow

Print at 0.08mm layer height or change the pause locations. I used a 0.4mm stainless steel nozzle\P1S\AMS 2 Pro

****Red and orange bleed seen in earlier preview images has been corrected by adding an additional paint layer****

If you like it give it a like so Bambu gives me free stuff {[*-*]}