Huge diamond ring

When printing PETG in vase mode, please ensure the build plate is clean! Avoid spaghetti

When printing PETG in vase mode, please ensure the build plate is clean! Avoid spaghetti

When printing PETG in vase mode, please ensure the build plate is clean! Avoid spaghetti

It is best to print on a smooth build plate for a smoother ring surface

No glue needed, press to snap into place for installation, the magnetic control light battery can be replaced

accessories:

1. Magnetic induction light, 10mm diameter Luminous Magnetic Control LED Model 10mm Magnetic Induction Anime Figure Nepal Perler Beads Acrylic DIY Light - Taobao

2. Round magnet, D6x3mm specification, if you do not want to install magnets on the ring, the cut-out in the model can be removed

Installation tips:

Since the ring surface is printed in vase mode, an inner layer ring surface was made to increase strength and refraction effect

The tolerance between the inner and outer layers is very small, installation may require careful and strong tapping, a perler bead hammer is recommended