iPhone SE 3/2 gen 8/7 TPU AMS Valentine's day

Before you start reading, if you are happy with my project, remember to leave a nice like and give 5 stars to the print profile

Thank you very much

!! ATTENTION !!

I've been told that sometimes prints, with Textured PEI plate, tend to stick too much. It's true

I've printed many to test, and I've learned a few small tricks: besides letting the plate cool down well, I don't clean it before printing, but rather I dirty it with my hands - the normal grease we have on our hands limits the adhesion of the cover to the plate - then I use the Bed Scraper https://makerworld.com/it/models/88371-bambu-lab-bed-scraper#profileId-1524370) or also this one which is lower https://makerworld.com/it/models/12703-bambu-bed-scraper#profileId-12705
The engineering plate is more suitable for use with TPU, but it doesn't come with the texture effect

I have also obtained better results by lowering the plate temperature. The TPU still sticks anyway
Let me know in the comments if it works well
Happy printing

Here is a perfect cover for a Valentine's Day gift for your loved one
It's a project for the Bambu Lab AMS TPU. I haven't found any others available
The filament is quite rigid and solutions with classic TPU don't work because you can't insert the phone
Projects with rigid filaments have shapes that poorly cover the phone, leaving some areas exposed to allow it to be inserted
Then it falls, hits exactly that exposed spot, and breaks
So I designed a project compatible with TPU for AMS, also to take advantage of the beautiful potential of multicolor prints
After several hours of design and as many tests, to also enable the maneuverability of the buttons, I created the solution you see
I have also provided an adequate hole for thick Lightning connectors. The previous cover I bought had a hole that was too small and it was a problem
I haven't tested it with PLA, if you try it, share it in the comments
I have prepared minimal and easily removable supports for a better print. But it can also be done without
The print is already optimized to consume less filament and doesn't have a prime tower because I saw that it's not needed
If you are interested, click "follow" on my profile and you will be notified of my new projects
If you liked the project, leave a nice like, it will help me continue
Let me know what you think in the comments and attach photos, you will help other users and earn MakerWorld points

Remember to also check my other projects, you might find something useful

Happy printing everyone