[New 2.5D version] Minecraft Totem of Undying Layered Painting (Fill the plate, dedicated for stalls, multiple specifications available)

Minecraft Totem of Undying Layered Painting

Updated 2026/5/10

New 2.5D version with light-colored protrusions

Model introduction below:

Dedicated for stalls!!

If individual printing is desired, you can manually skip or deselect parts before printing

Made using the open-source project "Lumina Studio" by the great @QAQ .

Images are from the original textures within the Minecraft game.

Open-source address: https://github.com/MOVIBALE/Lumina-Layers

This model requires layered printing with four colors: red, yellow, blue, and white, with not many color changes, and non-original filament with small color differences also prints well

Note:

Before printing, ensure the printing plate is clean, manually enable bed leveling, and the sinkage rate in the filament settings must be the same

When scaling, be careful not to change the Z-axis height. If scaling down, you need to check if layers 1-5 after slicing are too small to print properly; if so, you need to scale up.