Search models, users, collections, and posts
Donald J. Trump fridge magnet
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2 h
3 plates
Open in Bambu Studio
Boost
60
107
5
4
86
32
Released
Description
The pockets inside these models accept Ø6x4mm and Ø12x2mm magnets for the back and bottom positions respectively. It is best to keep the polarity of the magnets consistent between individual prints. In the double magnet version, the 6mm magnet should be inserted with a polarity such that it is slightly attracted towards the 12mm one.
3MF files include tested presets. Generally, use no larger than 0.4n and 0.2l. Some improvement in quality can be achieved with 0.15l. All models can be printed with 0% infill and 2 perimeters. Make sure to not overheat the magnets!
The use of Prusament Orange is mandatory :D.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (5)