Tired of your drying rack being taken up by small items like socks and underwear? This Space-Saving Laundry Hanger is the perfect 3D-printed solution to maximize your laundry space!

Designed specifically for standard drying racks with 14mm diameter tubes, this 20cm long attachment features 18 flexible spring-tension arms and 17 dedicated slots. It allows you to quickly slide in socks, underwear, bras, or baby clothes without the need for traditional clothespins.

Key Features:

Universal Fit: Snaps securely onto standard 14mm drying rack rails.

High Capacity: Hang up to 18 items in just 20cm of space.

Smart Design: The wavy "spring" geometry provides enough tension to hold light fabrics securely while making them easy to pull off when dry.

Durable & Compact: A sleek, one-piece print that organizes your laundry room instantly.

Print Settings
To ensure the "spring" mechanism works correctly and doesn't snap, I recommend the following settings:

Material: PETG is highly recommended for its flexibility and resistance to heat (especially if used near radiators). PLA works but may become brittle over time.

Infill: 15-20% (Grid or Gyroid).

Perimeters (Walls): 3-4 walls to ensure the clips and springs are sturdy.

Layer Height: 0.2mm or 0.28mm for a faster print.

Supports: No supports needed if printed on its flat side.

Orientation: Print it lying flat on the "spine" for maximum strength along the clips.

Post-Printing
Simply snap the C-clamp section onto your drying rack tube. If the fit is too tight or loose, you can slightly scale the model in your slicer by 1-2% to match your specific rack diameter.