Large Water Bottle

There's 2 different versions of the bottle (one with a loop and one without) and 2 different caps. I split the loop cap into 2 parts for easier printing and will need to be secured with epoxy. The gasket will need to be printed at a resolution of 0.12 or less as it's an extremely tight fit in the lower lip of the cap. The water bottle doesn't need supports but the 2 piece cap does. Dimensions are 246.75 x 102.6. Holds about 46.5oz of water.

Notes:

For best results, fill the edges of the bottom cap with epoxy and put the top cap on. Use a toothpick of something similar to fill in the gap between the top and bottom. You'll need to cut/grind away the inner seam on the bottle where the gasket comes into contact so the cap spins easier.