Rubik's Cube - 100% 3D Printed

A Fully 3D Printed Rubik's Cube

Features:

• Simple Assembly
• Completely Functional
• Customisable
• Easy To Print
• A Fun Fidget

Assembly:

This Rubik's cube is assembled exactly the same as any standard 3X3

* Add the coloured caps AFTER assembly *

• First, assemble the 'Core' and 'Centre C' by pressing the male pins into the female cups

• These are a very tight fit and require a fair bit of force to pop into place.

• Be careful not to twist the centre pieces as you press them into the core, as you are likely to snap the male pin.

• Once the core is assembled with 6X Centre pieces, follow the example video below:

Extra Info:

• This is not a speed cube and should be used with more care than a standard Rubik's cube.

• Tolerances between blocks are fairly loose to allow for easy push fit only assembly. This does mean that this cube is a bit looser than an injection moulded equivalent.

• Coloured caps are tight enough to push fit in place. This can depend on different filament brands though, so there is a potential need for a dab of superglue under any loose ones.

• 6 Colours are needed for a full cube, however, the included print profile is set up with no more than 4 colours per plate. This allows it to be printed with 1 AMS lite and manual colour changes (If you add some pauses)

Thanks for looking!

Please rate and review your printing experience and leave any improvements or suggestions in the comments below :)

If you like this print - Please try my Fidget Puzzle Wheel here:

https://makerworld.com/en/models/239042#profileId-254874