Valentines Candy Vending Machine

It's a fun model to print, it takes around one day/24 hours to print but it is worth it.

Infill - 15%

Supports - Yes

-Instructions-

1. Prep pieces by removing supports and sanding edges if needed.

2. Take the base and the rod with the heart on it and stick it till you can see it go through the first circle.   -WARNING- DO NOT TURN TOD WHILE IN SLOT. MAY DAMAGE FINS ON THE ROD

   

3. Take the rotor and stick in the hole in the base from the top lining the wholes up so the rod can go through.

   

4. Next, Push rod all the way through till the front of the heart hits the flat part of the base.

5. Take the the stopper and put a small dot of glue on the end of the rod extruding out from the stopper and then put it in the whole in the end of the rod and make sure it's securely in.

   

6. Then, put the jar in the ring on the top of the base. (You can glue it in if you want but you don't have to.)

   

7. Finally, put your small candy like MM's in it and enjoy!