Search models, users, collections, and posts
Quilmes Shield Keychain
IP Report
This model is created by Image to Keychain
Make Your Model
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Open in Bambu Studio
Boost
6
28
3
0
46
24
Released
Description
Content has been automatically translated.
It is a design to print face down. The settings I used for my print were:
- Nozzle: 0.4 mm
- Filament type: PLA
- Wall generator: Arachne
- Ironing: None
- Infill density: 15%
- Initial layer line width: 0.4 mm
If you found it useful or like the design, give it a “Like”.
Any suggestions and/or comments are welcome :)
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (3)