Search models, users, collections, and posts
Demoness with Maul | 100mm & 180mm
IP Report
Print Profile(2)
180mm, 0.16mm layer, 3 walls, 12% infill
Designer
6.8 h
2 plates
100mm, 0.16mm layer, 3 walls, 12% infill
Designer
3 h
2 plates
Open in Bambu Studio
Boost
3
4
0
0
0
0
Released
Description
A demoness with maul, last two images show source image and PrintU render.
Tried several attempts with makerlab PrintU to get something close to my source image, but this was the best I could muster.
I added horns and replaced the terrible AI sword with a maul, as well as some other general cleanup in meshmixer. The maul and hand print separately for gluing later, much safer print this way.
Partially powered by MakerWorld-printU (https://makerworld.com/makerlab/printU)
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)