Saab 900 Turbo Air Intake 7517147 Rubber Seal
Print Profile(1)
Description
This is a replacement for the rubber seal (part 7517147) connecting the crankcase pipe to the side of plastic air intake pipe (part 7514615) between the air-filter and the turbo charger on a Saab 900 turbo. I had some stringing issues with the print - make sure to clean up the inside of the seal after printing. Especially the recess needs to be checked.
It is a tight fit and the seal needs to be pressed into the pipe. I recommend to remove the pipe from the car completely. Use silicon spray to ease the install, Make sure that the lip on the end of the crankshaft vent pipe seats correctly in the recess.
Printed in TPU. I just completed this and just has a short test run with the car. So far it holds, but I am unsure how well TPU will cope with the heat of the engine
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)