Search models, users, collections, and posts
Aruba AP-615 Wall mount
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.6 h
1 plate
Open in Bambu Studio
Boost
5
19
1
0
36
19
Released
Description
Needed a wall mount for a few Aruba AP-615 access points, so did a remix of an already exisiting model from Thingiverse.
The model can also be used for ceiling but then the AP would be vertical.
Scale to 10% if you use the .STL file directly.
This should fit AP-6xx models and maybe also some AP-5xx models if using the same sliding system.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)