Search models, users, collections, and posts
MTG Coffin Deck Box (Remix00)
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
12.3 h
2 plates
Open in Bambu Studio
Boost
34
142
5
2
95
31
Released
Description
I made some changes to this great original to better suit my personal taste.
- I’m using twelve 8×3 mm magnets and added a pause in the print to place them below the top surface.
Just use a small amount of glue when the print pauses (don’t push on the print) so the nozzle doesn’t lift the magnets out again. - I changed the colors, as the original setup created more waste than I wanted.
- I added some extra details. The pentagram on the front can be glued on later. I used a bit of heat to make it fit even better (be careful — PLA doesn’t handle heat well).
- I adjusted the height to fit my needs for a standard deck (60 + 20 sleeved cards).
- I also added the year on the bottom — because why not.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (5)