Bose Proflight 2 mount for 737

Stefan created the original Airbus mount for the Bose Proflight 2, then I found a remix done by “timnaj”. 

The airbus mount will not work in the 737, so I remixed to add a way to hang this on the metal window shade slide bar. I also put the clips where you hang the headset (when not in use) on the back side of the mount so that it hangs straight down and doesn't swing the mount in. It also makes it less likely that you will knock the headset off the clips when you get in/out of the seat. 

I created two other versions of this mount where the clips are on the side of the holder. This makes it so the blinking green light faces backwards (pick Captain or First Officer build plate) in case you find that distracting. Although, this does make the mount wider, which takes up room in the case.

The print takes approximately 1 hour and uses 27g of filament.

Printed in 15% infil, rectilinear. 

Use tree supports on build plate only. There is no need to use any kind of support interface since the supports are minimal and come off easily.