Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.7 h
1 plate
Open in Bambu Studio
Boost
10
51
2
1
55
27
Released
Description
Content has been automatically translated.
IKEA plant pot, in this case, it is for the plastic ones that have a base of approximately 83mm and a neck of 120mm you can use slightly larger sizes for both measurements as it has good tolerance
The print in the photo is made with 0.6 nozzles and 0.3mm layer height, you can adjust it as you like
Important: To achieve the roughness shown in the photo, you must enable fuzzy skin on the outer perimeter in the slicer
Printed with Sunlu PLA+ 2.0 Bone color
If you liked it, don't forget to boost it
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)