Boot and Glove dryer for a 4x10 Floor register

This will temporarily replace your 4x10 floor register.

To save on material and time as well for added strengths I used 1.5" ABS from Home Depot.

The glove sections use 12" of 1.5" ABS pipe and the boot sections use 8" of 1.5" ABS pipe.

I made the glove sections higher as to not interfere with the boot soles. You can cut as needed depending on your gear.

I feel PETG is best for this project. Also best to prep the print plate with glue stick.

Note: The boot piece needs to be glued together.

Note: I am told some 4x10 floor registers holes can be tight if they were not cut properly.