270 Degree Door Hinge - Designed for 3D Printing - Free 3D Print Model

Search models, users, collections, and posts

KYZ Design

Hobby & DIY>Other Hobby & DIY

IP Report

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

Strong, 1 set, 0.2mm layer, 6 walls, 25% infill

39 min

1 plate

4.9(53)

One left side bolt head up and one right. 0.2mm layer, 5 walls, 15% infill

1.4 h

1 plate

5.0(14)

Open in Bambu Studio

Boost

565

1425

1.1 k

718

Released

Description

I use this for my 3D printer enclosures - sometimes you want to open the door and get it out of the way.

The mounting holes are for “6 gauge” or 4mm countersunk screws, the pivot is M4x30 cap screw (if you get a longer one with an un-threaded shaft portion and cut it down, it's even better).

Designed for 3D printing, not mimicking a metal or injection moulded part. Print in the orientation it loads in, no supports, minor overhangs.

Comment & Rating (74)

@SocinPower

0.32 layer height 0.60 layer width Amazing design. Wonderful hinge. I will use these for my enclosure DIY project. Thanks for this model buddy. I will share photos when it's ready. I am not sure yet about some parts. I am open to discussion! Thanks again.

(Edited)

@max7581

Boosted

Print Profile

Strong, 1 set, 0.2mm layer, 6 walls, 25% infill

great product, it does its job well

Show original

@KingsPrintz

Boosted

Print Profile

One left side bolt head up and one right. 0.2mm layer, 5 walls, 15% infill

cooles design

@lukass154

Print Profile

Strong, 1 set, 0.2mm layer, 6 walls, 25% infill

perfect for enclosure making

@MaxWeidner

Boosted

Print Profile

Strong, 1 set, 0.2mm layer, 6 walls, 25% infill

Made from ABS

Show original

@Merry_Husek

Boosted

Print Profile

Strong, 1 set, 0.2mm layer, 6 walls, 25% infill

Very good

@Peter.

Boosted

Print Profile

Strong, 1 set, 0.2mm layer, 6 walls, 25% infill

sieht sehr gut aus.

@MrFadedGlory

Boosted

Pretty cool hinge. A 5/32 by Inch and a half cotter pin works great for the pin. It's real tight in the bottom hole so I had to push it through pretty hard but it seats great and does not come out. There is no slop in the hinge either. Good model, Thanks!!